Before you begin
This page checks sound, touch and storage on this iPad. It sends nothing anywhere. Results stay here until you copy them.
- Hold the iPad sideways. Turn the volume up to about three-quarters. Use the built-in speakers (no Bluetooth).
- Do the checks in order: 1 Sound, 2 Touch, 3 Speed, 4 Screen, 5 Storage.
- Then go to Results and tap Copy results.
- Do it once in Safari, then add this page to the Home Screen and repeat checks 4 and 5 from the new icon (instructions in check 5).
You are using: …. Sound setting for this visit: ….
Page version .
1 · Sound
A. Start the sound
Did you hear a short beep?
Sound not started.
B. Silent mode
Silent mode is the bell in Control Center (swipe down from the top-right corner). Tell the page what it is set to now:
Play each beep, then say whether you heard it.
Do this with silent mode OFF, then ON. Then switch the sound setting and do both again:
C. Leaving and coming back
- Choose what you will do:
- Tap Start repeating beep.
- Press Home (or lock), wait about 10 seconds, then come back.
- Tap Resume and say whether the beeps came back.
2 · Touch
Notes held: keys being pressed now. Still fading: sounds finishing after a key is let go; normal for a moment. Only your ears can confirm a stuck sound.
What to do (tap to show)
- Hold 2, then 3, then 5, then as many fingers as you can on the keys. Lift them in any order. After each, check that the status returns to All clear and that you hear nothing.
- Put two fingers on the same key. Lift the first, then the second. Repeat, lifting the second first.
- Press a key, slide your finger off the keys, then lift.
- While holding notes: open Control Center, then come back. Then press Home and come back. Then rotate the iPad.
- If you hear a sound that keeps going with no finger on the screen, even if the counters say 0, do not stop it yet: tap I can hear a stuck note, then Stop all sounds.
Do not change any iPad settings. Just answer below if the iPad switched apps when you used four or five fingers.
3 · Speed
Part 1: tap the grey area 20 times, about once a second. The page measures what it can see inside the browser.
No taps yet.
Part 2: sound recording (approximate)
- Put a phone or microphone about 10 cm from the tap spot and the iPad's speaker. Quiet room.
- Start recording. Tap the grey area firmly 20 times, one per second, so each tap makes a small tick.
- In a sound editor (for example Audacity), measure from the start of each soft tick to the start of the loud click.
- Enter the results below. Optional: repeat in GarageBand with the same setup.
This is approximate. The tick is when the fingertip hits the glass, which can be slightly before the screen registers the touch.
4 · Screen
Tap Save snapshot in landscape, then rotate to portrait and tap it again, then rotate back. Repeat from the Home Screen icon later.
Measurements
5 · Storage and Home Screen
A. Storage check
Tap once. It only uses its own test data and removes it afterwards.
B. Add to Home Screen
- In Safari, tap the Share button (square with an arrow), then Add to Home Screen, then Add.
- Go to the Home Screen and open the new Diag icon.
- In the icon version, do checks 4 Screen and 5 Storage again, then copy the results there too.
You are using: …
Results
Paste the copied text into a message or note and send it back. If copying fails, press and hold in the box below, choose Select All, then Copy.